I'm pleased to present you the January The Floating Islands Set vol. 2. This set will be available for my Tribers in February.

Models from this set are made for FDM printing and do not require using any supports.

This set can be used as a expansion for my the most popular set, The Floating Islands Set vol. 1, as well as independent product.

This set will be useful even for people not interested in flying islands - there’s a lot of independent scatter terrain and elven architecture in this bundle.
Also, top parts of islands can be glued or attached using magnets. If you decide to not using glue, you can use these parts as hills and other non-floating scenery.

The islands need to stand on 1 inch rods (1” in diameter and 150mm/200mm/250mm+ tall) that can be printed or purchased (for example, on Amazon. Unfortunately, acrylic clear rods can be quite expensive. I suggest to check out hydraulic products, you can find some interesting 1” rods/pipes).

In the files you will find printable rods with a height of 15cm and 20cm.

All the islands are printed in two parts (+base) and can optionally use magnets.

The maximum size of the magnets that can be used for the islands is 15mm (diameter) x 3mm (height). If you are using lower magnets, I suggest you use some kind of putty or thick glue to fill the slot.

The upper parts of the islands have been designed to be an interesting element of the scenery even when lying flat on the table. In this way you can get interesting hills with columns, crystal formations or a shrine, for example.

The set also includes separate lower parts of the islands without any holes - they can be used as hills and rock formations.

The islands should stand firmly on the table thanks to the printable base decorated with crystals.

Files included in this set:

1” rods (150 and 200mm)

Independent models:

Elven Pillar (2 variants)
Elven Shrine
Elven Stone (2 variants)

Elven Structures (7 variants)
Elven Tower
Elven Tower - Overgrown variant
Elven Tower - Overgrown and ruined variant
Hill with Crystals (2 variants)
The Orb of Illumination

Floating Island Type #1

Floating Island #1 - Bottom
Floating Island #1 Top - Crystals
Floating Island #1 - Top - Elven Stone
Floating Island #1 - Top - Elven Structure #1
Floating Island #1 - Top - Elven Structure #2
Floating Island - Base - 1” hole

Floating Island Type #2

Floating Island #2 - Bottom
Floating Island #2 Top - Crystals
Floating Island #2 - Top - Elven Shrine
Floating Island #2 - Top - Elven Tower
Floating Island #2 - Top - The Orb of Illumination
Floating Island #2 - Top - Triple Elven Columns
Floating Island - Base - 1” hole

NOTE:

The miniatures presented in the pictures (dwarf, female druid and warrior) are made by Duncan "Shadow" Louca and are shown only for the scale. They are used with the knowledge and consent of the author. They are not included in the presented product.

3DHexes

MYMINIFACTORY

MAKERS

CREATORS

PARTNERS

SUBSCRIBE

APP