Voronoi vase
Voronoi vase
Published 2021-06-17T10:01:38+00:00
UPPER PART RAFT NEEDED
Decorative vase that is printed in 2 parts.
Print instructions
The files are pre-configured just press slice and you will have everything ready to print.
The lower part only consists of an outer perimeter and an inner one without filling, since otherwise it will create artifacts that will spoil the surface.
In the upper part of the vase I have increased the z-hop to 0.8 so that when moving along the piece it does not break it.
If you experience problems with the part breaking due to hitting the nozzle, it may be caused by that particular filament expanding more than it should, this is very common in silky filaments.
IF THE NOZZLE HITS THE PIECE BREAKING IT, REDUCE THE EXTRUSION MULTIPLIER TO 0.95
Date published | 17/06/2021 |
Support Free | YES |