Reciprocal Vase
$3.50 Reciprocal Vase
Published 2021-02-24T12:09:17+00:00
My wonderful Patreon supporters get this model free! :)
After reworking the Wicker Concentric Vase with its layers and criss-crossed sections I wondered how close I could get to the same kind of effect using a single spiraling line of filament...
Read the original writeup on Patreon here:
https://www.patreon.com/posts/reciprocal-vase-47857250
note: there's now a v2 version of the model uploaded as well, which addresses an angle near the top that was troublesome on some printers!
This is a vase mode print, so set your slicer accordingly! In Cura, this is called Spiralize Outer Contour. If you're using one of the few slicers that doesn't have such a mode, you can simulate it by using no infill or top layers.
Date published | 24/02/2021 |
Price | $3.50 |
Support Free | YES |
Beautiful vase! Thanks!