Puzzle Cube Maze
Puzzle Cube Maze
Published 2018-05-31T17:53:23+00:00
I took my Education Puzzle cube project designed in TinkerCAD and incorporated a maze into two of the cubes designed using the lesson developed for junior high and high school students. In the coming weeks I plan to add a directions on how to turn a puzzle cube into a puzzle cube maze.
The challenge is two fold: 1) Assemble the 3x3 cube using the 5 pieces. Keep an eye on the holes becuase, when assembled, they complete an internal maze. 2) Using a .15" ball bearing (the same size ball bearing found in last years fidget spinner 608 bearings) start in one of the outer holes and guide the ball through the maze. Be careful not to get stuck in a trap somewhere along the path. As a hint, going through the maze one direction is markedly easier thatn going in the opposite direction. If you get trapped in the maze, disassemble the cube to find the ball and try again. Remember to use the assembly time to map out the maze. It will make doing the maze a little less challenging.
You will need a .15" (5/32") or similarly sized steel bearing. https://amzn.to/2J2EZzT or harvest from 608 skate bearings popular in fidget spinners. https://amzn.to/2H7gq3i
The project scales well if you want to try larger or smaller prints and need various bearing sizes: https://amzn.to/2xuO5EB
There are pieces for two 30x30x30 cubes and a box to hold each.
Print all 5 pieces for cube version 1 and/or version 2. These print fine at .2mm layer heights and 2-4 walls/perimeters. Make sure the pieces are oriented properly on your build plate. Supports are not needed if oritned correctly. (Do not use internal supports!!)
I recommend printing the cube box using vase mode/spiralize the outer contour to hold your puzzle cube. I used natural filament for the box so the pieces could be seen inside.
Date published | 31/05/2018 |
Dimensions | 30x30x30mm |
Technology | FDM |
Complexity | Easy |
Support Free | YES |