Compensation plate for filament sensor
Compensation plate for filament sensor
Published 2021-03-05T10:40:13+00:00
Dies ist eine Ausgleichsplatte für den Filament Sensor beim Verbau eines BondTech BMG Extruders am CR-10 V2. Es wurden der Höhen- und Tiefenversatz berücksichtigt. Für die Montage des Sensorgehäuses werden 4x M3 Gewindeeinsätze, z.B. von Ruthex benötigt. Die Ausgleichsplatte muss vor der Montage des Extruders mittels 4 Senkschrauben DIN 7991 - M3 x 8 montiert werden.
Gedruckt wird das Teil mit der großen Planfläche nach unten. Stützen nur im Bereich der großen Bohrungen,
This is a compensation plate for the filament sensor when installing a BondTech BMG extruder on a CR-10 V2. The height and depth offset were taken into account. 4x M3 threaded inserts, e.g. from Ruthex, are required for mounting the sensor housing. The compensation plate must be installed using 4 countersunk screws DIN 7991 - M3 x 8 before the extruder is installed.
The part is printed with the large flat surface facing down. Supports only in the area of the large holes,
Date published | 05/03/2021 |