Sandman DS Flame Gun (Logan's Run)
Sandman DS Flame Gun (Logan's Run)
3D
Published 2014-10-28T21:07:07+00:00
This is my version of a Flame Gun from Logan's Run. It has a spring loaded trigger and the cap on the back can be removeable. I've left room for those of you that may want to add electoronics. There is room in the back of the barrel to insert batteries or electronics and easily access them by popping off the back cap. There is also room in the handle below the trigger although that space can ony be accessed during assembly. I've included some printed screw heads for those that want it completely 3D printed but they are small and hard to print. I also included a toggle switch that can be printed or you can drill into the print and mount a real toggle. With this gun you can take out all the runners you ever dreamed of. Good luck and happy hunting!
I used the High setting for PLA with a temp of 230°C for the raft and first few layers then I put the temp back to 220°C. 2 shells, 15% infill and 0.10 layer height.
| Date published | 28/10/2014 |
| Time to do | 480 - 600 minutes |
| Material Quantity | about 50g |
| Complexity | Easy |